Emulsion ADM80-1

Product Name: Emulsion ADM80-1

Description:

Emulsion adm80-1 is a solvent-free (no VOC) silane/siloxane emulsion. The product is designed as a water-repellent admixture for highly-filled external textured coatings. The silane/siloxane reacts with the fillers or aggregates within the textured coating film providing a permanent water repellent effect to the coating film.

Recommended Uses:

Exterior textured coatings are popular due to their architecturally-appealing nature. Such coatings are unfortunately very permeable to water. This water permeability is a result of their high Pigment Volume Concentration (usually in the range of 60-80 PVC). As a consequence, these coatings show relatively poor weathering resistance. The ingress of water through the coating causes discolouration, efflorescence and general degeneration of the coating.

Exterior textured coatings can be made water repellent by the inclusion of Emulsion adm80-1.

Emulsion adm80-1 is added at a concentration of 0.25-1% by weight to the coating during the final in-plant mixing stage. The resultant coating exhibits excellent surface beading (as shown in figure 1). The coating film has very low water absorption. The water resistance is developed very quickly, preventing wash-down due to rain or dew contacting the coating before cure. The water absorption through the coating is reduced by up to 95%.

As coating formulations vary, it is always recommended that a test be carried out prior to application to find the suitability of this product for the purpose.

Figure 1. Excellent beading effect of coating film

Standard Textured Coating:
The water droplet is absorbed through the coating

Textured Coating with ADM80-1:
It shows excellent beading effect of water droplet

Use Instructions:

Emulsion adm80-1 is easy to use. The following instructions should be followed when using Emulsion adm80-1:

Stir Emulsion adm80-1 before use.

Add the correct amount (0.25 – 1% by weight) during the final blending of the coating. Blend thoroughly to ensure even dispersion.
The product is water-based and all equipment can be cleaned with water.

Typical Data:

  • Appearance: Milky white liquid with slight odour
  • Solids content: 50% by weight
  • Specific Gravity: 1.0 gm/ml
  • pH value: 7-8 Solubility in water: Nil Flash point: >100ºC

Important Note:

As products and the conditions of use vary, it is always recommended that a pilot trial should be carried out prior to using Emulsion adm80-1 to determine the suitability of this product for the purpose.

Handling & Storage:

Emulsion adm80-1 is classified as a non-hazardous material according to the criteria of Worksafe Australia. However, as with all chemical products, good industrial hygiene procedures should be followed when using this product.

The product should be stored in closed containers in a cool dry place away from any fire sources.

The product has a shelf life of 12 months in a sealed container stored at a temperature below 25oC.

Packaging:

Emulsion adm80-1 is available in 20 and 200 litre plastic drums or 1,000 litre plastic bulky bin. Other size containers may be available on request.

For more information

Enquire Now
Fields marked by an asterisk ( * ) are required fields.

    One of our Tech-Dry team members will contact you shortly to process your order.